5 Steps to Make Electronic Cigarette E-Liquid Juice
An electronic cigarette, also known as e-cigarette, delivers a small dose of nicotine to the smoker through vaporizing liquid. This e-cigarette is composed of a long rechargeable battery, an atomizer or the heating element and a mouthpiece which contains a sponge-like substance that serves to hold the liquid before it is vaporized. The commercial refill liquid can be purchased in many flavors which contain different nicotine strengths. However, some users of e-cigarette make their own refilling liquid at home by mixing the ingredients. There are several ingredients which are available. The nicotine containing liquid EASYMix can be bought as well. All you need are steps to make electronic cigarette vapour liquid.
Step 1: Materials and knowledge to be Prepared
The things you are going to need in making Electronic cigarette e-liquid include the following:
Read all articles on this website first!
dropper bottle (30 ml or larger)
vegetable glycerin (VG) and or propelene glycol (PG)
nicotine liquid or EASYMix
distilled water (optional).
Step 2: Prepare the propylene Glycol (PG) and/or Vegetable Glycerin (VG)
Fill the syringe with 10 - 20 ml of VG or PG and deposit it to the dropper bottle. Instead of using only vegetable glycerin or propylene glycerin, you can use both and mix them .
The vegetable glycerin-based liquids can make an electronic cigarette produce more vapor than that of propylene glycerin-based e-liquids when exhaled.
Step 3: Measure Nicotine Liquid
Now, draw 10 ml of nicotine liquid into the syringe and place it into the bottle. To create 18mg/ml you need to dilute with the same amount of VG/PG. The result will be 20ml. to create 9mg you should add the same amount again. (20ml) The result will be 40ml
Step 4: Prepare the flavour and the Distilled Water (only needed when you use mostly VG)
Again with the use of the syringe, measure 1-3 ml of the distilled water and add it to the dropper bottle. Since vegetable glycerin has high viscosity, it is required to mix it with other liquids to thin it out before using it in an e-cigarette. After you’re done putting the water inside the bottle, put the cap and shake the bottle very well so as to mix the two liquids together. The same for your concentrated flavours. In general: 10 -15% is normally enough.
Step 5: Mixing the Liquids Altogether
Put the cap of the dropper bottle and shake it to vigorously mix the liquids altogether. After you’re done with the mixture, you can now apply the recommended drops to the cartridge.
Some Reminders when Creating Your Solution
The above mixture accounts that nicotine is 18mg of the overall content of the formula. Nicotine level must not exceed 34mg of the mixture. The e-cigarette refill liquid does not necessarily need to contain nicotine. If you want to have flavored vapour wiyhout nicotine, you can just leave the nicotine liquid out of the mixture.
PLEASE NOTE: Nicotine must be handled with extra care and keep out of reach of children and even animals.
When you have considered the 5 steps above plus these reminders, then it will be easier creating your own electronic cigarette vapor liquid. With a few handy tools and materials, you’re on your way to creating your own flavour.